Axis Communications 209FD M12 Installationsanleitung Seite 12

Page 12
Lens adjustments
Position
To adjust the position of the lens, follow these steps:
1. Open the Live View page in your
web browser.
2. Using the supplied allen key, loosen
the 2 locking screws, as shown here.
3. Insert the allen key into the small
hole in the lens casing.
4. While checking the image in the
Live View page, move the lens to
the desired position.
5. When the camera shows the
required view, gently retighten the
locking screws (torque < 0.4 Nm).
Focus
The focus of the AXIS 209FD/FD-R/FD-
R M12/MFD/MFD-R/MFD-R M12 is set
at the factory from 0.5m to infinity. It
does not normally need adjustment.
To focus on objects closer than 0.5m, or
if for some reason the lens has lost
focus, this can be adjusted in the
following way.
1. Loosen the focus lock screw.
2. Manually rotate the lens to adjust
the focus until the image on the
Live View page is satisfactory.
3. Gently retighten the focus lock
screw.
AXIS 209FD/FD-R/FD-R M12/MFD/MFD-R/MFD-R M12 Installation Guide
Locking screw
Insert Allen
key here
Locking screw
Focus lock
screw