Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CLEANING AND MAINTENANCE

CONTENTS:
0.0 WEEKLY CLEANING
1.0 ROUTINE MAINTENANCE
2.1 - CONDENSING COIL
2.2 - FANS
2.3 - POWER CABLE
2.0 LONG SHUTDOWNS
This section has been dedicated to the end-user and is extremely important for the appliance to work correctly in the long-term.
A few simple operations conscientiously carried out at set periods can avoid the need of servicing by specialized personnel.
The operations to be made do not require any particular technical knowledge and can be summarized in simple controls of the
appliances components.
IMPORTANT
BEFORE BEGINNING ANY TYPE OF MAINTENANCE OR CLEANING WORK ON THE APPLIANCE DISCONNECT THE MAINS
POWER SUPPLY.
WARNING
DO NOT WASH THE APPLIANCE DIRECTLY WITH HIGH PRESSURE WATER JETS. AVOID SPRAYING WATER DIRECTLY
ONTO ELECTRICAL PARTS.
1.0 – WEEKLY CLEANING
1.1 - THE BODY WORK
1.1.1 - Check that the body work is clean. Pay particular attention to the sections in steel.
1.1.2 - Clean the inside and outside surfaces only with VROR or with warm water and soap or a neutral detergent.
1.1.3 - Rinse with plenty of water and dry thoroughly.
1.2
- DEFROST WATER DRAIN SYSTEM, automatic for version normal temperature type Hamburg.
1.2.1 - Check that the condensate water drain pipe is not blocked. Clean if necessary.
1.3 - Defrost system at low temperature plant stop type Oberstdorf . Use a sponge and/or a cloth to remove the defrosting water
2.0 ROUTINE MAINTENANCE
2.1 - CONDENSING COIL
It is important that the coil is capable of offering the maximum possible heat exchange. It is therefore important that its surface be
always free of dirt or dust that may be deposited by the effect of the fan's operation.
2.1.1 - Use a vacuum cleaner and soft bristled brush to remove all the impurities such as paper or dust that may have deposited on the
coil.
2.1.2 - Check that the aluminum fins have not been damaged or bent, if this is the case "comb" the coil with the appropriate tool until
the original condition is regained to optimize the air flux.
2.3 - POWER CABLE
2.3.1 - Check that the power cable that connects the appliance to the mains socket is not cut, cracked or altered in such a way as to
compromise the insulation. Contact your authorized service center if this requires maintenance.
3.0 LONG SHUTDOWNS
If the appliance is inactive for long periods of time proceed as follows:
3.1 - Turn the main switch to the OFF position.
3.2 - Remove the plug from its socket.
3.3 - Empty the appliance and clean as in point 1.0.
3.4 - Leave the door ajar to avoid bad odors from forming.
3.5 - Protect the compressor group from dust.
IMPORTANT
AVOID USING DETERGENTS OR SIMILAR CLEANERS THAT MAY BE DETRIMENTAL TO ITS PROTECTION.
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Cool-line waste 240/2

Inhaltsverzeichnis