.
Service programmes
The Calc'nClean button will light up
S e r v i c e p r o g r a m m e s
every so often, with the exact frequency
depending on the water hardness and
usage of the appliance.
The appliance should be immediately
cleaned and descaled using the
programme.
Notes
Important: If the appliance is not
■
cleaned and descaled in good time,
it may be damaged.
Caution! For each of the service
■
programmes, use Calc'nClean
descaling and cleaning agents as
described in the instructions and
observe the (relevant) safety
information.
Do not drink the liquids.
■
Never use vinegar, vinegar-based
■
products, citric acid or citric
acid-based products for descaling.
For cleaning and descaling only use
■
the tablets intended for such
purpose.They have been specially
developed for this appliance, and
new stocks can be ordered through
customer service. ~ "Accessories"
on page 10
Never insert descaling tablets or
■
other products into the brewing unit.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Clean the
milk frother.
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion.
Service programmes en
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel, so cloths must
always be washed out thoroughly
before use.
If the service programme is
■
interrupted, e.g. by a power failure,
'and Calc'nClean will light up.
Then proceed as follows:
Rinse out the water tank.
1.
Pour in fresh, still water up to the
2.
"max" marking.
Touch Calc'nClean button.
3.
The programme starts and rinses the
appliance.Duration: approx.
2 minutes.
Empty, clean and re-insert the drip
4.
tray. Close door.
The programme has finished. The
appliance is ready for use again.
21