AEG Voxtel D235 Startanleitung Seite 19

If the handset registration is successful, you will hear a confirmation tone
and the will stop flashing.
The handset will automatically be allocated the next available handset
number. This handset number is shown in the handset display in standby
mode. If the handset registration is unsuccessful, the
10.5 To register an additional wireless headset
Important:
The wireless headset is pre-registered when supplied and should not
need to be registered. Headset registration is only necessary when you
buy a new headset or if it has lost its registration, and the headset LED
is purple.
Note:
Before trying to register a headset to the base station, make sure the base
station system pin code is set to "0000", otherwise you will not be able to
register the headset.
Press and hold volume up key
to put the headset into registration mode. The LED on the wireless
headset will toggle between red and blue.
Press and hold
the base station into registration mode.
Place the unregistered wireless headset on the base charging bay.
The headset LED will flash blue for about 3 seconds and a long beep
tone is generated if the registration is successful.
Note:
If the headset LED flashes slowly in purple, it means that the headset is
registered but the base is not available.
10.6 Reset your phone
You can reset your phone to the default settings. After a reset, all your
personal settings, call list entries, redial list entries, and answering machine
messages will be deleted but your phonebook remains unchanged.
Press and
OK
Press to display "PIN?-----".
Enter the 4-digit system PIN (default "0000").
OK
Press to display "CONFIRM?".
OK
Press to confirm, and the phone will be reset to its default settings.
18
on the base station for more than five seconds, to put
/ to select "DEFAULT".
together with volume down key
19
will still flash.
19