Climadiff CBI28S1B Gebrauchsanweisung Seite 48

selected, the display will flash before showing the current internal cooler temperature. The set
temperature can be viewed at any time by pressing the temperature select buttons
• If the appliance runs after a power failure, the previous set temperature does also exist as the
control panel has the memory function.
When the surrounding temperature is 25℃ and the wine cooler has no bottle
loaded, it will take around 30 minutes to increase the wine cooler's temperature
from 5℃ to 12℃. Under the same circumstance, it will take around one hour to
decrease the wine cooler's temperature from 12℃ to 5℃. The less the
temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
6. EQUIPMENT
The climate control system
According to advice from specialists, the ideal temperature for storing wine is around 12°C, within a
bracket of 10 to 14°C. Do not confuse this with service temperature, which varies between 5 and
20°C, depending on the specific nature of the wine.
It is especially important to avoid sudden changes in temperature. Designed by specialists for
oenophiles, this appliance, unlike a simple refrigerator, takes into account the sensitivity of grand cru
wines to sudden variations in temperature by ensuring the close control of a constant average
temperature.
The anti-vibration system
The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is
insulated from the body by a thick layer of polyurethane foam. These characteristics prevent the
transmission of vibration to your wines.
Defrosting
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the
appliance's refrigerated surfaces are defrosted automatically. The defrost water is channeled into a
condensates evaporation tray which is located in the back of the appliance near the compressor. The
heat produced by the compressor then evaporates the condensates collected in the tray.
Shelves
•
To prevent damage to the door seal, ensure that the door is fully open before pulling out the
shelves to add or remove bottles.
•
For easier access to the contents of the shelves, slide the shelf out approximately one third of the
way. The shelves are, however, fitted with a stop to prevent the bottles falling out.
•
To remove or reposition the shelves, move the shelf to the position where the notch of wooden
shelf is exactly under the plastic post and lift the wooden shelf. Please ensure these are replaced
when the shelf is put back.
48