To reset the function touch
To activate or deactivate function (only for
charcoal filter):
1. Switch on the control panel.
2. Make sure that the icons are turned
white.
3. To activate function touch
seconds.
7. CARE AND CLEANING
7.1 Notes on cleaning
Cleaning Agents
Keep the hood
clean
Charcoal filter
7.2 Cleaning the grease filter
Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
1. Pull the cover to open it.
Be careful! To prevent accidental
collapse, the cover has two hooks on the
sides.
for 3 seconds.
for 3
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters
carefully from fat. Fat accumulation or other residue may cause fire.
Follow the instructions for cleaning the accessories when filter notification is on. Refer to
Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may
discolour, it has no influence on the performance of the appliance.
The time of saturation of the charcoal filter varies depending on the type of cooking and
the regularity of cleaning the grease filter. Charcoal filter is washable, clean or regenerate
the filter after approximately every two months. Refer to leaflet included in the accessory.
If the function is activated, the filter icon
flashes five times.
4. To deactivate function touch
seconds.
If the function is deactivated, the filter icon
flashes three times.
2. Press the handle of the mounting clip on
the filter panel underneath the hood (1).
62
for 3