Voltr GTJ250WAC Bedienungsanleitung Seite 39

REPAIR
PROBLEM
The engine will not start
The engine works but
nothing moves
The machine smokes
during use
The cutter cuts do not cut or
cut badly
The cut-offs vibrate strongly
30/03/2023
POSSIBLE CAUSE
The plug is not connected
The extension is not properly
connected
Damaged device
Damaged device
Worn or too short cutting wire
Cutting wire or broken coil
Berrage Vegetable materials
The cutting wire is too worn or
uneven and therefore causes an
imbalance
SOLUTION
Connect the power supply to the
instructions
Use a compliant and suitable exten-
sion
Do not use the device, contact Voltr/
Alice's Garde after -sales service
Do not use the device, contact Voltr/
Alice's Garde after -sales service
Replace the wire or coil (see 'repla-
cement of the wire coil')
Replace the wire or coil (see 'repla-
cement of the wire coil')
Clean on the outskirts of mobile parts
Replace the wire or coil (see 'repla-
cement of the wire coil')
EN
39