Installation Tips - Niko 350-20058 Gebrauchsanleitung

350-20058, 350-20158
Read the complete user manual before carrying out the installation and activating the system
1. DESCRIPTION
The motion detector uses Passive Infrared Technology (PIR) and is suitable for outdoor use. Lighting control through motion
detection is useful for driveways, gardens, houses, holiday homes, car parks and public places.
The outdoor motion detector is available in two versions: White (350-20058) and Anthracite (350-20158).
2. INSTALLATION
2.1. Positioning
The outdoor motion detector reacts to motion and heat in its environment. It is most sensitive to diagonal movement (walking
direction) with respect to the detection beams (fig. 1).

Installation tips:

- The recommended mounting height is 2 to 3 m. At a height of 2.5 m, the White outdoor motion detector has a maximum
detection range of 14 m at a detection angle of 180°.
Note: The maximum detection range of the Anthracite outdoor motion detector is 11 m.
- Do not install the outdoor motion detector near moving objects (such as tree branches and leaves), heat sources or air
currents. This can result in undesired activation of the outdoor motion detector.
- Do not position the outdoor motion detector towards the light source it is meant to activate.
Attention: Disconnect all power before installing the outdoor motion detector. Do not connect the device to the mains voltage
until installation is completed.
2.2. Mounting
Opening the outdoor motion detector (fig. 2)
A. Insert a screwdriver into the opening at the bottom of the outdoor motion detector. Open the locks on the cover using a
screwdriver.
B. Click the cover off.
Mounting (fig. 2) and connecting the outdoor motion detector
C. Ensure the arrows on the sensor portion and the outdoor motion detector housing are pointing in opposite directions.
D. Pull on the top of the sensor portion.
E. Release the clamp on the bottom.
F. Remove the sensor portion.
G. Guide the cable through the openings in the bottom of the housing and attach the unit to the wall. Connect the sensor
(fig. 3.1).
Connect a push button if manual operation of the outdoor motion detector is also desired (fig. 3.2).
H. Mount the assembly by placing the sensor portion back onto the bottom of the housing. Pay attention to the direction of
the arrows.
I. Hook the cover over the top and click it onto the sensor portion.
EN
13