Controller Self-Test - AEG ELFAMATIC uC 3000 Gebrauchs- Und Montageanweisung

Button
LCD
P AF M
-20 8
P
Only for
Powertherm
charging
P
model
M
14 : 53 14 : 53

1.6 Controller self-test

The ELFAMATIC µC 3000 must be de-energised before the self-test can be started. Then press
–
+
the and buttons simultaneously and switch the power supply back on at the same time.
XXXX 8888 VR LF LZ KU
88 : 88 88 : 88
%
C
, ,
Button
LCD
EEP
M
M TAST
E/A
M
TEMP
-214
Outside temperature
Button
–
+
VR LF LZ KU
or
ED
SH
° C
,
SYN
VR LF LZ KU
LF
-- : -- -- : --
LZ VR LF LZ KU
-- : -- -- : --
VR LF LZ KU
ED
SH
SYN
M
ED
SH
SYN
Display segment test
Button
VR LF LZ KU
ED
00
SH
SYN
VR LF LZ KU
P
ED
SH
SYN
–
+
VR LF LZ KU
or
ED
1A
SH
SYN
VR LF LZ KU M
ED
SH
° C 2x
,
SYN
Note
Display of the average outside temperature used for calculating
the charge.
The currently measured outside temperature value is entered in
the memory by holding down the
simultaneously for longer than 3 seconds.
Stored main release time
ED
SH
SYN
Stored additional-release time
ED
SH
SYN
VR LF LZ KU
M
ED
SH
SYN
Bemerkung
EEProm memory version
Button test – An internal device test is performed to check
that the buttons are functioning correctly.
P
Press the button. The buttons
already pressed during the self-test and therefore do not need
to be tested again.
Output test – The relay and Triac can be activated alternately
+
by pressing the buttons
End – If no button is pressed for 2 seconds, the display returns
to the standard mode.
For the Fitter
–
+
and buttons
VERS VR LF LZ KU
ED
100
SH
,
SYN
Software version
–
+
M
, and were
–
and .
29