Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
▶ CPU Base Clock Apply Mode [Auto]*
Sets the applying mode for adjusted CPU base clock.
[Auto]
This setting will be configured automatically by BIOS.
[Next Boot]
CPU will run the adjusted CPU base clock at next boot.
[Immediate]
CPU runs the adjusted CPU base clock immediately.
[During Boot]
CPU will run the adjusted CPU base clock during boot.
< DRAM Setting >
▶ DRAM Reference Clock [Auto]*
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
▶ DRAM Frequency [Auto]
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
▶ Adjusted DRAM Frequency
Shows the adjusted DRAM frequency. Read-only.
▶ Extreme Memory Profile (X.M.P) [Disabled]
X.M.P. (Extreme Memory Profile) is the overclocking technology by memory module.
This item will be available when you install the memory modules that support X.M.P.
technology.
[Disabled]
Disables this function.
[Profile 1]
Uses profile1 over-clocking settings of installed XMP memory module.
[Profile 2]
Uses profile2 over-clocking settings of installed XMP memory module.
▶ Memory Try It ! [Disabled]
It improve memory compatibility or performance by choosing optimized memory
preset.
▶ DRAM Timing Mode [Auto]
Selects the memory timing mode.
[Auto]
DRAM timings will be determined based on SPD (Serial Presence
Detect) of installed memory modules.
[Link]
Allows user to configure the DRAM timing manually for all memory
channel.
[UnLink]
Allows user to configure the DRAM timing manually for respective
memory channel.
▶ Advanced DRAM Configuration
Press <Enter> to enter the sub-menu. This sub-menu will be activated after setting
[Link] or [Unlink] in "DRAM Timing Mode". User can set the memory timing for each
memory channel. The system may become unstable or unbootable after changing
memory timing. If it occurs, please clear the CMOS data and restore the default
settings. (Refer to the Clear CMOS jumper/ button section to clear the CMOS data,
and enter the BIOS to load the default settings.)
En-42
Werbung
Inhaltsverzeichnis
