General Information - iFactory3D One Pro Bedienungsanleitung

EX_97971.02

General Information

Read the instructions carefully. By using the machine, you confirm to
have read the assembly instructions as well as the safety, maintenance
and warranty advice!
Safety advice / How to use
Unintended use and wrong handling can lead to machine fault.
The extension can just be used on a genuine iFactory3D One Pro belt printer and is meant to support long printed objects, that
exceed the printer's footprint.
It is possible to print objects that are longer than the supported area. The amount of support required heavily depends on the
centre of gravity of the printed parts, which should always be supported.
Careful!
Parts can move/rotate during printing. Do not touch the device during printing.
Maintenance
Only use replacement parts approved by iFactory3D GmbH.
Do not use lubrication on the device.
Leveling of the extension must be performed before operating the printer. The level may change per printer and after each
recalibration of the printer.
Warranty
Modification of the extension by replacing parts or other mechanical processing will lead to loss of warranty for all modified
parts and all damage caused thereby.
3