Operations; Straight Weighing; Backlight Function; Re-Zero Function - Mettler Toledo RN10-CNRS Bedienungsanleitung

METTLER TOLEDO

Operations

Straight weighing

Place the item to be weighed on the platter.
Enter the unit price (The price to pay will come up in the total price display simultaneously).
Remove the item from the platter, all displays will return to 0.
Backlight function (Option)
Some versions of TIGER II are equipped with a backlight for both the operator display and the customer display.
When the light of the environment is not bright enough to get a clear reading from Tiger II's display, the
backlight can be switched on.
Press and hold the C-key until a longer beep is heard, then two continuous beeps will be heard to indicate the
C
backlight has been switched on.
Use the same procedure to switch the backlight off or just turn the scale off.
When the scale is not used for 15 seconds, the backlight will automatically switch off; when a weight is placed
on the platter or when a key is depressed, the backlight will switch on again.
Note: Please check the model name to see if the scale has backlight function.

Re-zero function

There are two ways to re-zero the scale, power-up zero and push button zero
☞ Power-up Zero
The scale will automatically capture zero when it is turned on. The power-up zero capture range is ±10% of the
scale capacity. When the scale is turned on with a weight on the platter of more than 10% of the capacity, or
with less weight than -10%, the scale will not capture zero (the weight display will show "-----") and the scale
will not be ready for use. After removing the weight or put the weight on the scale will capture "zero".
☞ Pushbutton Zero
The ZERO key re-zeros the scale over a range of ±2% of the scale capacity. To use this function, the scale must
>0<
be in the gross weighing mode (NET cursor must be off) and in a no motion condition. When the weight on the
platter is more then ±2% of the scale capacity the depression of the zero key will not be accepted.

Tare Function

The Tare key subtracts the weight of the wrapping material.
☞ Tare Function
Place the empty container or wrapping material on the platter.
>T< Press the T- key.
Place the item to be weighed in the container or on the wrapping material and then onto the platter.
Enter the unit price.
Remove the weighed item and the container or wrapping material from the platter, the displays will show all 0.
To fix the tare, please refer to key-FIX function.
Tiger II
GB
7