Device Start-Up; Firmware Updating - Vimar ELVOX Videocitofonia PIXEL UP 40415.S Installationsanleitung

PIXEL UP: 40415.S

5.2 Device start-up

Status
A - Switch-on
B – Secondary module detection
C – Secondary module firmware updating in progress
D – Device operational
Times: 0.25 s ON, 0.75 s OFF.
1
Times: 1.00 s ON, 0.75 s OFF.
2
C status is only achieved when there are secondary modules to update.
6.

Firmware Updating

The outdoor station firmware can be updated via the Web configuration interface: refer to the relative manual.
Status
On
Updating – STEP 1
Updating – STEP 2
Updating – STEP 3
Times: 0.25 s ON, 0.25 s OFF.
3
The firmware updating procedure of the electronic audio video module is performed in three steps, each of which is identified
by a specific aspect of the LEDs as indicated above. After updating, the device restarts automatically.
LED L3
ON
OFF
OFF Flashing
OFF
LED L3
ON
OFF
OFF Flashing
Flashing Flashing
3
EN
LED L2 LED L1
ON ON
OFF Flashing
Flashing
1
OFF OFF
LED L2 LED L1
ON ON
OFF Flashing
Flashing
3
Flashing
3
1
1
3
3
3
15