Philips GC9500 Serie Bedienungsanleitung Seite 14

EnGlish
14
Problem
The light in the on/
off button flashes.
Water droplets
come out of the
soleplate.
Wet spots appear
on the garment
during ironing.
Water spots appear
on the garment
during use of
the steam boost
function.
Flakes and
impurities come
out of the soleplate
or the soleplate is
dirty.
Water leaks
from the steam
generator.
All manuals and user guides at all-guides.com
Possible cause
The auto-shut-off function is activated
automatically when the steam generator has
not been used for more than 10 minutes.
When you start steam ironing and
when you continue steam ironing after
an interruption, the steam that was still
present in the hose has cooled down and
condensed into water. This causes water
droplets to come out of the soleplate.
The wet spots that appear on your garment
after you have steam ironed for some
time may be caused by steam that has
condensed onto the ironing board.
The water spots on your garment are
caused by condensation in the supply hose.
When the supply hose cools down, the
steam that is still present in the hose cools
down and condenses into water.
Impurities or chemicals present in the water
have deposited in the steam vents and/or
on the soleplate.
Too much scale and minerals have
accumulated inside the steam generator.
If you tilt the steam generator during
transport or place it on an uneven surface
when the water tank is full, water may spill
out of the water tank.
Solution
Press the on/off button to switch
on the steam generator again.
This is normal. Hold the iron over
an old cloth and press the steam
trigger. The cloth absorbs the
drops. After a few seconds, steam
instead of water comes out of the
soleplate.
Iron the wet spots without steam
for some time to dry them. If the
underside of the ironing board is
wet, wipe it dry with a piece of dry
cloth.
The water droplets stop coming
out of the soleplate when you have
used the steam boost function for
some time.
Clean the soleplate with a damp
cloth.
Descale the steam generator
regularly (see chapter 'Cleaning and
maintenance', section 'Descaling the
steam generator with the EASY
DE-CALC knob').
Do not tilt the steam generator
when the water tank is full.