Reset To The Factory Settings; Firmware Update - Airzone Aidoo Z-Wave Plus AZAI6ZWE Serie Bedienungsanleitung

The following interactions with the air conditioning unit will imply a combination of Z-Wave.
commands:
Description
Fan Off
Change Mode
It is possible to check the compatible Air conditioning indoor units in the Airzone compatibility
checker:
https://www.airzonecontrol.com/control_solutions/aidoo/wi-fi

RESET TO THE FACTORY SETTINGS

Please use this procedure only when the network primary controller is missing or ortherwise
inoperable.
The Aidoo Z-Wave Plus can be reset to the original factory settings by long pressing over the
Factoy Reset button
Note: If the reset is performed while the device is still part of a network, it notifies the other
devices in the Lifeline group that it has been removed.

FIRMWARE UPDATE

The Aidoo Z-Wave Plus supports over-the-air firmware updates that do not require the device
to be removed from its location. The firmware update can be activated from all certified
controllers supporting version 5 of the Firmware Update function.
Important: The Aidoo Z-Wave Plus will be rebooted at the end of the firmware update
procedure. It is advisable to carry out the firmware update procedure only when necessary
and following careful planning of the intervention.
Values
Off
Thermostat_Mode:
Auto chageover
Cooling
Heating
Fan
Dry
Thermostat_Setpoint
- SetpointType: (Heating,
Cooling, Dry Air)
- SetPointValue: (tenths of °C)
until all of the front side LEDs light up for a second.
Z-Wave Command
Thermostat_Fan_Mode
Thermostat_Mode
Thermostat_Mode
Thermostat_Setpoint
EN
13