Function and Device Design
EN
For mounting and installation
EN
• Have mounting and installation performed only by qualified and authorised persons
EN
(see chapter "Qualification of the personnel).
• The device is only to be installed in areas for which it is suited based on its marking.
EN
• During installation and operation, observe the information (characteristic values and
EN
rated operating conditions) on the rating, data and information plates located on the
EN
device.
• Before installation, make sure that the device is not damaged.
EN
• Electrical circuits with the "Ex i" type of protection can no longer be operated as circuits
EN
with this protection type after being operated with circuits with other types of protection.
EN
Commissioning, maintenance, repair
EN
• Only have commissioning and repairs performed by qualified and authorised persons
EN
(see chapter "Qualification of the personnel).
EN
• Before commissioning, make sure that the device is not damaged.
• Perform only maintenance work described in these operating instructions.
EN
EN
3.4
Modifications and Alterations
EN
EN
EN
EN
EN
EN
EN
EN
EN
4
Function and Device Design
EN
EN
6
Zone 2 Ex i Field Device Coupler 8 Spurs
Series 9411/24
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
• Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
Explosion hazard due to improper use!
Non-compliance results in severe or fatal injuries.
• Use the device only in accordance with the operating conditions
described in these operating instructions.
• Use the device only for the intended purpose specified in these
operating instructions.
DANGER
DANGER
207321 / 941160310190
2023‐03‐06·BA00·III·en·05