Herunterladen Inhalt Inhalt Diese Seite drucken

Chauvet Professional REM1SQ Kurzanleitung Seite 3

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Power Linking
It is possible to power link REM 1 and REM 1SQ products. See the table below for the current draw at each voltage and
frequency:
REM1
Current Draw
REM1SQ
Current Draw
Never exceed 12 A on a single circuit. Power-linking cables can be purchased separately.
Mounting
Before mounting this product, read the
or the M10 threaded mounting holes on the product. Make sure the mounting devices are capable of supporting the
weight of the product. For our Chauvet line of mounting clamps, go to http://trusst.com/productcategory/truss-clamps.
Mounting Diagram
Rigging eye bolt
Rig Bar speego (x3)
Alignment conical (x2)
M10 threaded mounting hole
Male speego
Male speego
Male speego
M10 threaded mounting hole
Warning! The magnetic attachments are not load-bearing, and are intended for alignment
assistance only. Do not release panel until the hanging hardware has been fully secured.
The M10 mounting points are not intended for hanging or suspending from a truss or other
overhead structure.
REM 1 and REM 1SQ QRG Rev. 1
QUICK REFERENCE GUIDE
100 V, 60 Hz
120 V, 60 Hz
2.4 A
100 V, 60 Hz
120 V, 60 Hz
1.2 A
Safety
Notes. Use rig bars (REM-RB50CMIP or REM-RB100CMIP) from Chauvet,
Alignment bolts (x4)
208 V, 60 Hz
2.0 A
1.15 A
208 V, 60 Hz
1.0 A
0.57 A
230 V, 50 Hz
1.04 A
230 V, 50 Hz
0.52 A
Female speego
Female speego
M10 threaded mounting hole
Female speego
Female speego
Male speego
M10 threaded mounting hole
EN
240 V, 50 Hz
1.0 A
240 V, 50 Hz
0.5 A
2

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Rem1

Inhaltsverzeichnis