Checking Signal Strength; Switching On/Off The Power To The Antenna; Restoring The System Defaults - Pioneer PDP-436SXE Bedienungsanleitung

Enjoying DTV broadcasts
Add New Channels
Search Information
Existing Channels
Channels Found
Progress 30%
• To quit a channel search in progress, press HOME
MENU.
NOTE
• The password entry screen does not appear if you have
disabled the password function. For details, see "Using a
password" on page 48.
• You can select "DTV Setup" only when watching DTV
channels.

Checking signal strength

You can check the signal strength and signal quality of each TV
channel.
1
Repeat steps 1 to 4 provided for "Adding New
Channels".
2
Select "Signal Check" ( /
3
Select "RF Channel" ( /
4
Select the channel to be checked ( / ).
Signal Check
RF Channel
Add New Channels
Signal Strength : 77%
0 25
Signal Quality : 100% Good
• Use "Add New Channels" function here to add channels
within the selected RF channel (receiving frequency).
NOTE
• You can select "DTV Setup" only when watching DTV
channels.

Switching on/off the power to the antenna

Use the following procedure to switch on or off the power to the
antenna connected with the DTV antenna terminal.
1
Repeat steps 1 to 4 provided for "Adding New
Channels".
2
Select "Aerial Power" ( / ).
All manuals and user guides at all-guides.com
Found Channels
04 001
************
20 002
************
003
******
004
************
then ENTER).
then ENTER).
21
50 75 100
3
Select "On" or "Off" ( / ).
Installation
Aerial Power
Country
Add New Channels
Replace Existing Channels
Signal Check
Restore System Defaults
NOTE
• You can select "DTV Setup" only when watching DTV
channels.

Restoring the system defaults

Use this function only when you wish to reset all the DTV
settings to the factory defaults.
1
Press HOME MENU.
2
then ENTER).
Select "Setup" ( /
3
Select "DTV Setup" ( /
4
Select "Installation" ( /
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select "Restore System Defaults" ( /
• A confirmation screen appears.
6
With "OK" pressed, the system restores the factory
defaults. Then Auto Installation is initiated automatically.
NOTE
• The password entry screen does not appear if you have
disabled the password function. For details, see "Using a
password" on page 48.
• You can select "DTV Setup" only when watching DTV
channels.
Off
Germany
then ENTER).
then ENTER).
then ENTER).
09
35
En