General Safety Instructions - Gude 94081 Bedienungsanleitung

1.1.7 5 in 1 Engine Scythe
Fig. 7
1.2 Warranty
Warranty claims according to the warranty certificate attached.
2

General Safety Instructions

Read the instructions for use thoroughly before the initial operation of the machine. If any doubts regarding
the connection and operation arise, consult the manufacturer (servicing department).
Observe the instructions shown below carefully to guarantee the high degree of safety.
Caution!
To be safe at working with this engine scythe, it is required that instructions and information on safety,
installation and operation contained in the manual are precisely observed. Any person engaged in the
operation or maintenance of the machine should be knowledgeable regarding the operation manual and
aware of any potential risk. Prevent children, the sick and infirm from access. While you are in the working
area, look after the children very carefully. Observe any regional and local safety precautions applicable in
your place. The same applies to any provisions on the safety at work and health protection in the work site.
The manufacturer shall not be held liable if the machines it manufactures are altered in an unauthorised
manner, in result of which damage was inflicted.
Warning! It is necessary to observe the essential safety precautions when using the machine tools. Kindly
follow the tips and instructions in the additional safety precautions.
1. Pay attention to the conditions of the area, which you're working in. After the engine is started,
the machine will produce poisonous flue gas. The gas may be invisible and odourless. Hence never
work with the machine closed or poorly ventilated areas. Provide for good lighting when cutting.
Provide for stability when working in wet, snow or icy weather conditions on slopes or rough ground.
2. Do not let any unauthorised persons approach the machine. The visitors and viewers, primarily the
children, the ill and infirm persons should not have any access to the working area. Prevent other
persons from any contact with the tools.
3. Make provision for the tools storage. The machines not in current use should be kept in a dry place,
elevated or locked where practicable so that any access to them is prevented.
4. Always use a correct tool for the job to be done. E.g. avoid using small tools and accessories for
work that should be actually done with a heavy tool. Use the tools only for the purposes they were
designed for.
5. Pay attention to adequate clothing. The clothing should fit the purpose and should not put any limits
to you when working. Wear clothing with stiffener protecting against cuts.
6. Use personal protection equipment. Wear safety shoes with steel toes/ steel or rough sole.
1. Lock screw
2. String protection
3.
25
String coil
GB