Making Cappuccino - BRAYER BR1114 Bedienungsanleitung

10 EN
pressure in the boiler is released, you can remove
the filter holder (5).
ESPRESSO PORTION SETTING
- To enter the programming mode, press and hold
the one cup button (18) «
button (18) « » illumination will be flashing.
Press the button (18) «
required amount of ready coffee is poured into the
cup, press the button (18) «
setting. Maximum time of water supply for making
one cup of coffee is 45 seconds.
- To enter the programming mode, press and hold
the two cups button (19) «
the button (19) «
flashing. Press the button (19) «
the required amount of ready coffee is poured into
the cup, press the button (19) «
finish setting. Maximum time of water supply for
making two cups of coffee is 90 seconds.
Notes:
- if you have programmed the water supply time
for making one cup of coffee, then the water
supply time for making two cups of coffee will be
automatically set doubled;
- water supply time for two cups of coffee can be set
up to 90 seconds. If the water supply time for two
cups of coffee was set, then the water supply time
for making one cup of coffee will be automatically
set as half the time for making two cups of coffee.
» for 3 seconds, the
» again. After the
» again to finish
» for 3 seconds,
» illumination will be
» again. After
» again to
RETURN TO THE FACTORY SETTINGS
• Switch the coffee maker on and wait for preheating, the
button (18, 19, 20) indicators will light up.
• After the preheating is finished, press and hold
simultaneously the buttons (20) «
» for 3 seconds, the buttons (19 and 20) illumination will
flash 3 times, and the espresso machine will return to the
factory settings.
• Switch the coffee maker off by pressing the on/off button
(17) « », the buttons (17, 18, 19, 20) illumination will
go out.
• Switch the coffee maker on by pressing the on/off button
(17) « », the settings will return to default.

MAKING CAPPUCCINO

ATTENTION!
Be careful to avoid burns by the released hot steam.
• Make coffee, as described in the chapter «MAKING
ESPRESSO», in a cup with enough capacity to add
frothed milk.
• Make sure that the steam control knob (9) «
the position «the steam supply is off «•».
• Press the steam supply button (19) «
the button (20) « » illumination glows constantly. Place
any suitable bowl under the tip (11) for water. Carefully
turn the steam supply knob (9) «
for a quarter of a turn to remove the condensed fluid from
the cappuccinator pipe (10).
» and (19) «
» is in
» and wait until
» counterclockwise