Cleaning Methods; Dry Vacuum Cleaning - Kärcher SE 4002 Bedienungsanleitung

Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
 Remove the accessories and the fresh
water reservoir and unlatch the motor
casing.
 Remove the motor casing and empty
the reservoir.
Cleaning tips/mode of operation
Always work from the light to the shade
–
(from the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
Rugs with jute backing can shrink if too
–
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
–
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care
–
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
Do not step on cleaned surfaces until
–
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.

Cleaning methods

Light/normal contamination
 Turn on suction and spraying
(position I).
 Spray and simultaneously suction off
detergent solution in one work cycle.
 Switch off the spray switch and suction
off the remaining cleaning solution.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
Heavy soiling or stains
 Switch on sprayer (position I).
 Apply detergent solution and soak for
10 to 15 minutes (suction is switched
off).
 Clean the surface just like you would
with light/normal soiling.
16
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
End wet cleaning process
 Rinse the spray tubes in the appliance
as follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.

Dry vacuum cleaning

Caution
Always work with the filter bag inserted, ex-
cept when a cartridge filter is used (option).
The reservoir and accessories must be dry
to prevent parts from sticking together.
Illustration
 Insert a filter bag.
Illustration
 Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn
the locking handle to secure it.
 Select the desired accessories and at-
tach to the spray/suction pipes or direct-
ly to the attachment.
 Switch on suction (position I).
Vacuuming hard surfaces
Illustration
 Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Vacuuming carpeted floors
Illustration
 Work without the hard surface insert.
 Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
– 5
EN