Cameo NANOBEAM 600 Bedienungsanleitung Seite 6

CONFIGURE DMX START ADDRESS
Press MENU to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "DMX address"
(coloured background) and confirm with ENTER. A number field is then displayed and you can configure the DMX start address as required
with the UP and DOWN keys (press and hold button for quick change in value, the highest value is dependent on the selected DMX mode).
Confirm the entry with ENTER and press MENU to return to the main display. The main display is activated automatically after approximately
1 minute of inactivity. The DMX start address is clearly visible in the middle of the display and the DMX mode is displayed on the bottom line
(CH-03, CH-05, CH-08, CH-12 CH-14).
CONFIGURE DMX MODE
Press MENU to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "DMX Mode" (coloured
background) and confirm with ENTER. A selection box is displayed and you can select the desired DMX mode with the help of the UP and
DOWN controls. Confirm the entry with ENTER and press MENU to return to the main display. The main display is activated automatically af-
ter approximately 1 minute of inactivity. The DMX start address is clearly visible in the middle of the display and the DMX mode is displayed
on the bottom line (CH-03, CH-05, CH-08, CH-12 CH-14). If the DMX signal is interrupted, the DMX address symbol will begin to flash. It will
stop flashing once the DMX signal is restored.
CONFIGURING AUTO MODE
Each of the 7 available auto programmes consist of a sequence of pre-configured colour change and motion sequences.
Press MENU to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "Auto Mode" (coloured
background) and confirm with ENTER. Use the UP and DOWN controls to select "Show Mode" and confirm with ENTER. Use UP and DOWN
to select the desired programme (Auto00 to Auto06) and confirm with ENTER. To configure programme run speed, use the UP and DOWN
keys to select the menu item "Show Speed" and confirm with ENTER. Use the UP and DOWN controls to select a value between 01 and 99
(press and hold for quick change of value. 01 = minimum and 99 = maximum speed). Confirm the entry with ENTER and press MENU twice
to return to the main display. After about 1 minute of inactivity, the main display is automatically activated and the mode is clearly shown in
the centre of the display.
6