BRAYER BR4004 Bedienungsanleitung Seite 4

4 EN
SAFETY MEASURES AND OPERATION
RECOMMENDATIONS
Read the operation instructions carefully before
using the iron, after reading keep them for future
reference.
• Use the unit for its intended purpose only, as it is
stated in this manual.
• Mishandling the iron can lead to its breakage and
cause harm to the user or damage to the user's
property, which is not covered by warranty.
• Make sure that the operating voltage of the unit
indicated on the label corresponds to your home
mains voltage.
• The power cord is equipped with a «euro-plug»;
insert it into a socket that has a reliable grounding
connection. In case of short circuit the grounding
reduces the risk of electric shock.
• Contact an electrical technician, if you are not
sure that your sockets are installed properly and
grounded.
• To avoid fire, do not use adapters for connecting the
unit to the mains.
• To avoid mains overloading, do not switch on several
electrical appliances with high power consumption at
the same time.
• Do not touch the unit body, the power cord and the
power plug with wet hands.
• Do not let the power cord be on the ironing board and
touch hot surfaces and sharp edges of furniture.
• Do not use the unit near heating appliances, heat
sources or open flame.
• Do not use the unit in proximity to the kitchen sink, in
bathrooms, near swimming pools or other containers
filled with water.
• If the unit is dropped into water, unplug it
immediately, and only then you can take the unit out
of water. Apply to the authorized service center for
testing or repairing the unit.
• •Do not use the unit in places where aerosols
are used or sprayed, and in proximity to highly
inflammable liquids, do not use the unit in the places
where such liquids are stored.
• Do not use the unit outdoors.
• It is recommended not to use the unit during lightning
storms.
• Protect the unit from impacts, falling, vibrations and
other mechanical stress.
• Do not leave the unit unattended. During breaks
in operation, put the iron on the base (in vertical
position).
• Before plugging the unit in set the temperature
control knob to the minimal position and switch the
continuous steam supply off.
• Always switch off and unplug the iron when you do
not use it.
• Fill the tank with water additionally cleaned with a