Parameter Set; General; Control Commands - Pfeiffer Vacuum HILOBE 8103 Betriebsanleitung

7 Parameter set
7.1 General
Important settings and function-related characteristics are factory-programmed into the electronic drive
unit as parameters. Each parameter has a three-digit number and a description. The use of the parame-
ter is possible via Pfeiffer Vacuum displays and control panels, or externally via RS-485 using Pfeiffer
Vacuum protocol.
The vacuum pump starts in standard mode with factory default pre-set parameters.
#
Display
Description
Functions
Data type
Access type
Unit
min. / max.
default
Tbl. 10:
7.2 Control commands
# Display Designations
002 Stand-by Stand-by
009 ErrorAckn Malfunction ac-
knowledge-
ment
010 PumpgStatn Pump
013 BrakeOn Activate brak-
ing resistance
019 Cfg DO2 Output DO2
configuration
024 Cfg DO1 Output DO1
configuration
026 SpdSetMode Rotation speed
setting mode
Non-volatile data storage
When switching off or in the event of unintentional voltage drop, the parameters and the
operating hours stay saved in the electronics.
Three digit number of the parameter
Display of parameter description
Brief description of the parameters
Function description of the parameters
Type of formatting of the parameter for the use with the Pfeiffer Vacuum protocol
R (read): Read access; W (write): Write access
Physical unit of the described variable
Permissible limit values for the entry of a value
Factory default pre-setting (partially pump-specific)
The parameter can be saved persistently in the electronic drive unit
Explanation and meaning of the parameters
Functions
0 = off
1 = on
0 = off
1 = on
0 = off
1 = on
1 = No error
2 = Error
5 = Set rotation speed
reached
6 = Pump on
9 = "0"
10 = "1"
11 = Remote priority active
Settings, see [P:019]
0 = off
1 = on
Data Ac- Unit min.
type cess
type
0 RW 0
0 W 1
0 RW 0
0 RW 0
7 RW 0
7 RW 0
7 RW 0

Parameter set

max. de-
fault
1 0
1
1 0
1 1
20 6
20 1
1 0
105/134