Klarstein VINSIDER 35D Bedienungsanleitung Seite 34

EN
34
Removing Shelves
To remove any of the shelves from the
rail com- partment, move the shelf to the
position where the notch on the shelf is
exactly under the plastic post then lift the
shelf to release it. When replac- ing the
shelves, always ensure they are correctly
located.
Humidity Control (Optional)
The wine cooler is equipped with a
system for maintain- ing the correct level
of humidity. Fill the small plastic res-
ervoir (humidity box) ¾ full with water,
and fit onto the runners found on the top
shelf of the wine cooler. Check the water
level regularly and refill as necessary.
Please en- sure the reservoir is positioned
correctly on the runners on the top shelf
to avoid the possibility of water spillage.
Cleaning Your Wine Cooler
• Turn off the power, unplug the appliance, and remove all items including shelves
and rack.
• Wash the inside surfaces with a warm water and baking soda solution. The solution
should be about 2 table- spoons of baking soda to a pint of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning any area of the
controls.
• Wash the outside cabinet with warm water and mild liquid detergent.
• Rinse well and wipe dry with a clean soft cloth.
Vacation Time
• Short holidays: Leave the Wine Cooler in operation for holidays of less than three
weeks.
• Long absences: If the appliance will not be used for several months, remove all
items, turn off the appliance and unplug. Clean and dry the interior thoroughly. To
prevent odour and mold growth, leave the door open slightly: blocking it open if
necessary.