Before First Use; Preparing For Use - Philips HomeRun 3000-Serie Bedienungsanleitung

English
8

Before first use

Preparing for use

0.5m
0.5m
1.5m
11 Charging contact points (robot)
12 Water tank
13 Release button of the water tank
14 Brush cover
15 Main brush
16 Power on/off switch
17 Front caster wheel
18 Sensor to guide the robot back to the station (3x)
19 Anti-drop sensor (3x)
20 Side brush
21 Main wheels
22 Mop pad holder
23 Washable mop pad (2x)
24 Dust bag (2x)
25 Canister lid
26 Dust bag compartment
27 Auto-Empty station
28 Indicator light
29 Charging contact points (station)
30 Auto-Empty inlet
31 Power cord socket
32 Placemat
33 Brush cleaning tool
1 Take the appliance out of the box and remove all packaging.
2 Remove the protection covers.
3 If you see any sign of visible damage, go to www.philips.com/support or
contact the Consumer Care Center in your country.
Tips for choosing the best location for installing the station:
-
Do not place the station in bright sunlight or under furniture. This will block
the infrared signal that helps the robot find its way back to the station.
-
Install the station on a level surface against a wall.
-
Install the station on a hard floor.
-
Do not place the station near stairs or a heating source (radiator).
-
Install in a location with good WiFi coverage.
Install the station
1 Install the station within the correct dimensions for placement.
Note: Keep 0.5 meters of space on the sides of the station and 1.5 meters
in front of the station.
2 Connect the station to the power supply.
3 Make sure that the remaining part of the power cable is well concealed
behind the station so that the robot cannot drive over it.
4 Place the dust bag in the dust bag compartment of the station.