Virtual Wall - Klarstein 10009786 Bedienungsanleitung

Press the power switch button "
4. Auto clean setting :
In normal working status of the charging base, press the full-go button "
function (when the battery is recharged fully, the robot will automatically start the cleaning work),.
Press this button again, this function will be disabled.
When the robot is fully charged, if both the timing cleaning function
and the full-go function are enabled, the timing cleaning will have priority.
When the battery power of the cleaner is low , it may be unable to seek the charging dock station for
recharge, for this case, please manually put the cleaner on the dock station and press the " + " button
for recharge.

Virtual Wall

The virtual wall is an accessory , it sends some special IR signals to form a blocked area to
prevent the cleaner from entering unnecessary areas, it is so named "virtual wall" because
this function acts like a wall.
01. Before using the virtual wall, install the batteries as shown in figure 3, open the bottom cover of
the virtual wall, install 2 pcs A batteries (pay attention to the correct polarity). After the installation,
close the bottom cover and tighten the screws.
02. Select the distance selector of the virtual wall according to the actual requirements; pull the shift
switch to the top position to select the low level(0-4m), to the middle to select the medium
level(4-7m) and to the bottom to select the high level( above 7m) ; See figure 2. the lower level,
the lower power consumption and the longer working time of batteries, therefore, you should try
to select a lower level whenever possible.
03. Press the power button on the virtual wall, the indicator will flash, when the voltage is normal,
the indicator will twinkle at each longer interval, if the batteries are in low power, the indicator
will flash faster, indicating that the batteries should be replaced, to avoid wrong startup, you
should press and hold the switch for a comparatively longer time (about 3~5 seconds) when
turning on the power.
04. The virtual wall takes effect with IR signals, therefore, its functional range is a sector of about
15°, when the power is turned on, you should place it at the entrance of the area that you don't
want the cleaner to clean, the cleaner won't enter such area then.
05. The virtual wall uses 2pcs A (1.5V)batteries, when batteries' power is short, you should replace
them, Continue to use the batteries with extremely short power may corrode the virtual wall.
IR guidance signal emitter
Wall signal emitter
indicator
Power switch
Distance selector
Figure 1
1.You need to use a screwdriver to open the bottom cover of the virtual wall (see Figure 3)
2.Please refer to figure 4 for the installation of batteries to avoid wrong polarity that may
the time setting status without saving the timing value.
Rubber pad
Figure 2
damage the virtual wall.
" or timing button "
Bottom cover
0-4m
4-7m
Over 7m
Figure 3
" will quit
" to enable the full-go
Figure 4
20