Westfalia ASS18E Originalanleitung Seite 11

 Use suitable detectors to determine if utility lines are hidden in the work area or call
the local utility company for assistance. Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead to explosion. Penetrating a water line
causes property damage or may cause an electric shock.
 Ensure that the lighting is adequate.
 Ensure that the reciprocating saw blade is securely fixed in the holder. Insecure
accessories can be ejected from the machine causing a hazard.
 Do not exert pressure on to the tool. To do so would shorten its service life.
 If you are interrupted when operating a reciprocating saw, complete the process and
switch off before looking up.
 Where possible, use clamps or a vice to hold your work.
 Examine the tool holder regularly for signs of wear or damage. Have damaged parts
repaired by a qualified service centre.
 Always wait until the reciprocating saw has come to a complete stop before putting it
down.
 Periodically check all nuts, bolts and other fixings and tighten where necessary.
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Additional Battery and Charger Safety Notes
WARNING: Li-Ion batteries, if incorrectly used, stored or charged are a fire, burn and explosion
hazard.
Use the battery charger correctly
 Refer to the section of this manual relating to use of the battery charger before
attempting to charge the battery.
 Do not attempt to use the charger with any batteries other than those supplied. Failure
to follow these instructions may cause overheating or fire.
 When battery pack is not in use, make sure the battery pack cannot be shorted
accidentally. Keep the battery clean at all times. Keep it away from other metal objects,
like paper clips, coins, keys, nails, screws or other small metal objects that can make a
connection from one terminal to another. Shorting the battery terminals together may
cause burns or a fire.
 Allow batteries to cool for 15 minutes after charging or heavy use. Failure to follow
these instructions may cause overheating or fire.
 Use only chargers recommended by the manufacturer to charge the batteries. If a
charger is not suitable for a certain kind of battery there is a risk of fire. Only use Li-Ion
batteries provided with a product or specifically designed to be compatible.
 Use power tools only with specifically designated battery packs. Use of any other
battery packs may create a risk of injury and fire.
 The unit is designed for operation in altitudes of up to 2000 m above sea level.
 Keep the battery out of reach of children.
 When not in use batteries should be stored at room temperature (approximately 20˚
C).
 Do not open, disassemble, crush, heat above 60° C or incinerate. Do not dispose of in
fire or similar.
11