Pepperl+Fuchs Ecom RSM-Ex 01-Serie Bedienungsanleitung Seite 4

Entity parameter cable
Uo (Peak) = 4.2 V / Io = 22.3 mA / Po = 23.5 mW / Ui = 4.2 V / Ci = 1µF / Li = 1µH / Pi =
400 mW
Ii = 300 mA / Lo and Co:
Lo [mH] 0.64
Co [µF] 2.3
Safety regulations:
Use of the device assumes that the user observes the conventional safety regulations
and has read the certificate in order to eliminate faulty operation of the device.
The following safety regulations are to be observed:
• Do not charge the device inside the Ex-area
• Do not open the device inside the Ex-area
• It must be ensured that the maximum input voltage (Um) for the device from the charger
between the lines is 6 V
• The ambient temperature during the charging shall be in the range from 0 °C to 45 °C
• Only those accessories approved by ECOM Instruments GmbH may be used
• Do not use the device in zones 0 or 20
For using in mining zone only
• The device must be protected against strong impacts for Group I
• The device must be protected against the constant contact with oils, hydraulic liquids
and fats
• The device must be removed from the Ex-area in case of fire damp
Approved accessory for the headset jack connector
RSM-Ex 01 has a jack connector where a headset can be connected.
Following headsets are approved and allowed to be connected to RSM-Ex 01
• ComCom Ex and additional in-ear plug Serenity SPC Ex
• RSM HS 01 -W
• RSM HS 01 -B
The approved headsets are allowed to connected and disconnected directly inside the
Ex-area.
Repair:
Repairs may only be carried out by ECOM Instruments GmbH or by service centers
authorized by ECOM Instruments GmbH, as the safety of the product must be checked
after conducting the repair. The repair request form can be downloaded under the Service
section at www.ecom-ex.com.
4
0.5 0.2 0.1
3.0 5.5 7.6
0.049 0.019 0.009 0.004 0.001 0.000
10 16 23 39 129 419