Panasonic EY4640 Bedienungsanleitung Seite 10

III. ASSEMBLY
NOTE:
When attaching or removing a slide
handle, disconnect battery pack from
tool.
CAUTION:
• Always be sure that the side handle
is installed securely before operation.
Screw the side handle securely as
shown in the figure.
CAUTION:
• Never actuate the lock pin when the
spindle is rotating. The tool may be
damaged.
Press the lock button to prevent spindle
rotation when installing or removing
parts, such as grinding disc, disc guard,
etc.
Installing or removing disc
Inspection before use
• Has the correct grinding disc
been mounted for the object to be
ground?
• Has the proper diameter of the
grinding disc been mounted for
the tool rating?
• Has the proper grinding disc
compiled to safety standard listed
below been mounted?
Europe – EN, Australia - AS
1
1. Grinding disc
guard
2. Spindle
3
3. Grinding disc
2
guard fixing
screw
- 10 -
CAUTION:
• When using, the Grinding disc guard
must be installed on the tool so that
the closed side of the guard always
faces toward the operator.
• Ensure that blotters are used when
they are provided with the bonded
abrasive product and when they are
required;
WARNING:
• Always use supplied guard when
using tool. Grinding disc can shatter
during use and Grinding disc guard
helps to reduce chances of personal
injury.
1. Install the Grinding disc guard, and
then securely tighten the screw.
Make sure
the side.
2. Install the disc flange and the disc
to the spindle in order as shown in
the figure.
3. Tighten the clamp nut onto the
spindle so that hollow side faces
opposite direction to the disc.
4. Push the Spindle lock button to
secure the spindle in place, and
then use the clamp nut wrench to
tighten the clamp nut securely.
1
5. To remove the grinding disc, follow
the installation procedure in reverse.
1. Clamp nut
1
2. Grinding disc
3. Disc flange
2
3
1. Spindle lock
button