Werbung
Circular work (Fig. 13, 14 & 15)
• Circular work may be accomplished if you assemble
the straight guide and guide plate as shown in
Fig. 13 or 14.
Fig. 13 for cutting circles between 70 mm and
121 mm in radius.
Fig. 14 for cutting circles between 121 mm and
221 mm in radius.
Note:
Circles between 172 mm and 186 mm in radius
cannot be cut using this guide.
• Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit)
are as follows:
Min.: 70 mm
Max.: 221 mm
Align the center hole in the straight guide with the
center of the circle to be cut. Drive a nail less than
6 mm in diameter into the center hole to secure the
straight guide. Pivot the tool around the nail in clock-
wise direction.
Templet guide (Fig. 19, 20, 21 & 22)
The templet guide provides a sleeve through which the bit passes, allowing use of the trimmer with templet
patterns.
Remove the tool base from the tool. Loosen the wing bolts and secure the tool base horizontally. Loosen the
two screws on the tool base.
Place the templet guide on the tool base. There are four convex portions on the templet guide. Secure two of
the four convex portions using the two screws. Install the tool base on the tool.
Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide
sliding along the side of the templet.
NOTE:
The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router
bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation:
Distance (X) =
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 29 & 30)
Replace carbon brushes when they are worn down to
the limit mark. Both identical carbon brushes should
be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
10
outside diameter of the templet guide – router bit diameter
Trimmer guide (Fig. 16, 17 & 18)
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base
horizontally. Install the trimmer guide on the tool base
with the clamp screw (A). Loosen the clamp screw (B)
and adjust the distance between the bit and the
trimmer guide by turning the adjusting screw (1 mm
per turn). At the desired distance, tighten the clamp
screw (B) to secure the trimmer guide in place.
When cutting, move the tool with the guide roller
riding the side of the workpiece.
2
ACCESSORY
Makita offers an extensive range of trimmer bits which
comply with the latest safety regulations. Specifica-
tions of each type can be found on the following
pages.
Werbung
