Important Information; Safety Instructions; Checking The Package Contents; Introduction - Viessmann 5578 Bedienungsanleitung

1. Important information

Please read this manual completely and attentively before using the product for the first time. Keep this manual. It is part
of the product.

1.1 Safety instructions

Caution:
Risk of injury!
Tools are required for installation.
Electrical hazard!
Never put the connecting wires into a power socket! Regularly examine the transformer for damage. In case of any
damage, do not use the transformer.
Make sure that the power supply is switched off when you mount the device and connect the cables!
Only use VDE/EN tested special model train transformers for the power supply!
The power sources must be protected to avoid the risk of burning cables.
1.2 Using the product for its correct purpose
This product is intended:
- For installation in model train layouts and dioramas.
- For connection to an authorized model train transformer (e. g. item 5200) or a digital command station.
- For operation in dry rooms only.
Using the product for any other purpose is not approved and is considered inappropriate. The manufacturer is not re-
sponsible for any damage resulting from the improper use of this product.

1.3 Checking the package contents

Check the contents of the package for completeness:
- Sound module with blue cable
- Mounting material (2 screws, 8 plugs)
- Manual

2. Introduction

Experience the model railway with all your senses: The stationary sound module provides the specific sounds to the
scenes in the animated world. The sound module is equipped with integral loudspeaker and connection for an external
loudspeaker.

3. Mounting

Fasten the module with the enclosed screws. To ensure an optimal sound reproduction of the module, please note the
following hints:
1. The loudspeaker is an integral part of the module. The upper surface of the module must always be uncovered in
order to provide a good sound dispersion.
2. If possible, gear the sound module towards the spectator, so please avoid upside down mounting under the layout.
3. The sound module should be installed near the respective functional model on your layout. You can also install the
module on the layout, e. g. in a building. This way you can even have a better sound and an optimal concordance
between the visible and the audible sound source.

4. Connection

Fitting cables: Due to the low current consumption thin cables can be used which can easily be hidden. It is recom-
mended to use a cross section of 0.14 mm² (e. g. Viessmann items 6860 – 6869 or 68603 – 68693).
For automatic operation (diorama mode) of the sound module, please refer to fig. 2 (section B). For manual operation of
the sound module, please refer to fig. 2 (section A).
It is also possible to operate the sound module without the eMotion model "Jukebox", item 1511.
4