Disposal - Endress+Hauser Liquiport 2000 Active cooling Betriebsanleitung

Liquiport 2000 Active cooling
"
!
Endress+Hauser
Caution!
• Do not return any devices if you cannot be entirely sure that you have completely removed all
traces of hazardous substances, e.g. any media which have penetrated crevices or diffused
through plastic.
• Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be
charged to the owner-operator.
For a return, e.g. in case of repair, the device must be sent in protective packaging. The original
packaging offers the best protection for this. Repairsmust only be carried out by your supplier's serv-
ice organisation. An overview of the service network can be found on the address page of these Op-
erating Instructions.
Note!
Please enclose a note describing the fault and the application when sending the assembly in for re-
pair.
8.6

Disposal

The device contains electronic components and these must, therefore, be disposed of as electronic
waste in the event of disposal. Please observe in particular the local waste disposal regulations of
your country.
Trouble-shooting
31