Specifications; Battery Removal/Installation - Hitachi WH 14DL Bedienungsanleitung

English
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using
this product, even if you are pulling the switch, the
motor may stop. This is not the trouble but the result
of protection function.

SPECIFICATIONS

Cordless Impact Driver
Model
Voltage
No-Load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
Cordless Impact Wrench
Model
Voltage
No-Load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
Charger
Model
Charging voltage
Charging time 3.0 Ah
Weight
Charge time is approximate. Actual charge time may
vary.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle 3 tightly and push the battery latch
2 to remove the battery 1 (See Fig. 1 ).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery 1 while observing its polarities
(See Fig. 1).
CHARGING
Before using the impact driver or impact wrench, charge
the battery as follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
5
1.
2.
WH14DL
14.4 V
140 N·m
EBL1430: Li-ion (4 cells)
3.0 Ah
BCL1430: Li-ion (4 or 8 cells)
1.5 kg
WR14DL
14.4 V
200 N·m
EBL1430: Li-ion (4 cells)
3.0 Ah
BCL1430: Li-ion (4 or 8 cells)
1.5 kg
UC18YRL
7.2 – 18 V
45 min.
0.6 kg
2. Insert the battery into the charger
CAUTION
3. Charging
(1) Pilot lamp indication
When the battery power remaining runs out (The
battery voltage drops to about 12V (WH18DL,
WR18DL) / about 8V (WH14DL, WR14DL)), the
motor stops.
In such case, charge it up immediately.
If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
0 – 2600 min
M6 – M14
EBM1830: Li-ion (10 cells)
0 – 2600 min
M10 – M16
EBM1830: Li-ion (10 cells)
Insert the battery firmly, until it contacts the bottom of
the charger compartment.
If the battery is inserted in the reverse direction, not
only recharging will become impossible, but it may
also cause problems in the charger such as deformed
recharging terminal.
When inserting a battery in the charger, charging will
commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals) (See
Table 1).
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
WH18DL
18 V
-1
150 N·m
1.6 kg
WR18DL
18 V
-1
220 N·m
1.6 kg