Troubleshooting - AEG 4.3 Bedienungsanleitung

www.aeg-automotive.com
34

TroUblesHooTInG

Problem
The monitor stays dark� The
blue leD doesn't light up�
The monitor displays no
image�
The image on the monitor
shows interference�
The monitor image is not
displayed clearly�
Possible cause
The 12 V monitor cable
plug is not plugged into the
vehicle's cigarette lighter or a
12 V outlet�
The fuse inside the 12 V mo-
nitor cable plug is burnt out
and must be replaced�
The camera is not connected
to the monitor�
The wireless connection
between monitor and camera
is too weak, thus interfering
with data transmission�
The camera lens may be dirty� Carefully clean the camera
bright light is hitting the
camera lens�
Solution
Plug the 12 V monitor cable
plug into the cigarette lighter
or a 12 V vehicle outlet�
replace the defective fuse
inside the 12 V monitor cable
plug with a new fuse (also see
"replacing fuses")�
Check the battery charge�
If necessary, recharge the
reversing camera�
Position the transmitter
closer to the monitor or
adjust the position of the
monitor�
lens�
The image quality will impro-
ve once you move out of the
area of the interfering light�