Assembly; Adjusting The Handlebar; Emptying The Dirt Container; Maintenance - Parkside PKM 24 A1 Originalbetriebsanleitung

Assembly

Removing the disc brush
1. Detach the dirt collection container (9).
2. Turn the device over.
3. Hold firmly onto the disc brush (6) and
turn the lock (7) to release
4. Remove the lock (7).
Mounting the disc brush
1. Detach the dirt collection container (9).
2. Turn the device over.
3. Place the disc brush (6) into the recep-
tor (8).
4. Insert the lock (7) into the recesses (12)
of the receptor.
5. Hold firmly onto the disc brush (6) and
turn the lock (7) to fix it in place
Mounting the lower bar
1. Place the lower bar (3) into the
fastening on the device housing (5).
The stud on the lower bar (3) must fit
into the guide rail (10) on the device
housing.
2. Fasten the lower bar (3) using a screw
and quick release lever (4) on each
side.
Mounting the handlebar
The height of the handlebar can be altered
by selecting one of two holes in the
handlebar.
1. Screw the handlebar (1) using the quick
release levers, screws and washers (2)
to the lower bar (3).
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the device.
Inserting the dirt container
1. Take hold of the dirt container (9) by
the handle (11).
2. Place the dirt container (9) into the

Adjusting the handlebar

↻
. 1. Release the quick release levers (4) on
2. Select one of the two possible positions
3. Fasten the lower bar (3) using the quick
Emptying the dirt
container
↻
. 1. Grip the dirt container (9) by the
2. Lift it out of the device housing.
3. Empty the dirt container (9).
4. Place the dirt container (9) into the

Maintenance

Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Replace damaged
parts.

Cleaning

• Clean the surfaces thoroughly after
device housing (5).
Setting the inclination
the lower bar(3).
on the front end of the guide rail (10).
release levers (4).
handle (11).
device housing (5).
Only use original parts.
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice. Never clean the device under
running water.
each use with a soft brush, paintbrush
or cloth.
GB IE
13