Commissioning And Operation - Klarstein Arctic-Porter Bedienungsanleitung

COMMISSIONING AND OPERATION

1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the appliance into the wall outlet, the "POWER" indicator blinks.
Note: Allow the appliance to rest for 30 minutes before plugging it in if it has been
moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
Note: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press "ON/OFF" button, and the "POWER" indicator lights solidly. At that time,
press "SELECT" button to select the ice size. If need to clean the appliance, press
"SELECT" button to select "CLEAN" function under standby mode.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the
ambient temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 7-15 minutes ice forms on the evaporator.
Once this has completed, the ice tray will tilt backwards and the remaining water in
the ice tray is drained back into the water reservoir. The ice cubes are then dropped
from the evaporator and pushed forward into the ice basket by the ice shovel. The
ice tray will automatically move back into position under the evaporator and start
the next cycle.
9. The "ICE FULL" indicator will light up when the ice basket is full and then the ice
cube maker will stop the ice-making cycle automatically. Gently remove the ice
from the ice basket with the ice scoop. About 7.5 seconds later, the ice cube maker
will restart its ice making function automatically.
10. 10. The "ADD WATER" indicator will light up when the water reservoir is lack of
water and the ice-making cycle will stop automatically. At that time, remove the ice
basket and add water to the water reservoir, and then press "ON/OFF" button
again to restart the ice-making cycle. The appliance will start working automatically
after about 20 minutes if the operator forgets to restart the appliance after refill.
1 1. When you have got your desired amount of ice, stop the ice making cycle by
pressing the "ON/OFF" button and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the appliance to reach room temperature.
14. Suggest replacing the water every a week. Please empty the water reservoir if the
appliance is not used for a long time.
EN
21