Philips PerfectCare 9000 Serie Bedienungsanleitung Seite 10

ENGLISH
12
30
Storage
31
32
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If you are unable to
solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Centre in your country (0 20 79 49 02 40).
Problem Possible cause
The ironing board cover Steam has condensed on the ironing
becomes wet or there board cover after a long ironing
are water droplets on session.
the garment during
ironing.
You have an ironing board cover that
is not designed to cope with the high
steam rate of the appliance.
Automatic steam mode has been used
for a long period of time.
Water condenses on Automatic/Max steam mode has been
the iron during ironing. used for a long period of time.
11
Keep the steam trigger pressed continuously while you move the iron on a piece of
thick cloth for 3 minutes (Fig. 30).
Warning: Hot, dirty water comes out of the soleplate.
12 Stop moving the iron when no more water comes out.
13
You can continue to use the appliance immediately. Otherwise unplug the appliance
after the descaling is completed.
1 Switch off the appliance and unplug it.
2 Put the iron on the iron platform. Push the carry lock to lock the iron onto the
platform.
3 Remove the water tank and empty it.
4
Wrap the steam supply hose around the base.
5 Slot it into the supply hose storage compartment by pushing the hose through the
gap (Fig. 31).
6 Fold the mains cord with the velcro provided, and insert it into the cord storage
compartment (Fig. 32).
7 You can carry the appliance with one hand by the handle of the iron.
Note: Do not carry the appliance by holding the water tank release lever
Note: If there is calc/fibre build up around the ActiveSense camera, remove it gently with
a cotton swab or equivalent.
Solution
Replace the ironing board cover if the foam
material has worn out. You can also add an extra
layer of felt material under the ironing board
cover to prevent condensation on the ironing
board. You can buy felt in a fabric shop.
Put an extra layer of felt material under the
ironing board cover to prevent condensation on
the ironing board. You can buy felt in a fabric
shop.
Switch off the automatic steam mode and use
the manual trigger to activate the steam when
needed.
Switch off the automatic/Max steam mode and
use the manual trigger to activate the steam
when needed.