Parts Identification - Panasonic EW‑DL40 Bedienungsanleitung

Parts identification





 


A Main unit
1 Toothbrush shaft
2 Waterproof rubber seal
3 OFF/ON button
4 Mode selector
5 Mode indicator
6 Battery capacity lamp
7 Charge status lamp
B Charger (RE8‑4)
8 Charging section
9 Brush stand
EW-DL40_EU.indb 3









: Charger cover release
button
; Charger cover
 Power cord
Accessories
C Double‑edge brush
 Bristles
 Identification ring
D Carrying case
Store and Charge
Storing and charging the toothbrush
The battery capacity is low when the battery capacity lamp
blinks.
You can fully charge the toothbrush in 1 hours.
A full charge will supply enough power for 60 minutes use.
1
1
Pass the power cord through one
of the cord guides on the right or
left.
2
2
Turn off the main unit.
3
3
Place the main unit upright on
the charger and plug the
power cord into a household
outlet.
•
The charge status lamp glows and the charging will start.
•
Charging is completed when the battery capacity lamp
blinks.
•
You can keep the main unit attached on the charger when
not in use to maintain the full battery capacity. It will not
overcharge the main unit.
•
Adequate ambient temperature for charging is 15‑35 °C.
The lifespan of the rechargeable battery may shorten when
charging at 15 °C or less.
3
2009/07/28 20:30:04