Storage; Care And Maintenance; Maintenance Intervals; Refilling Oil In The High-Pressure Pump - Kärcher WRS 200 Benutzerhandbuch

Lock
1
9. Unscrew the high-pressure hose from the high-pressure
connection of the WRS 200. Fit a protective cap to pre-
vent soiling.
Storing the high-pressure hose
1
High-pressure gun with spray lance
2
Holder with rubber latch
3
Mounting
4
10.Fit the high-pressure gun with spray lance into the
mount and holder and secure with the rubber retainer.
11.Open the right-hand door and place the high-pressure
hose in the storage compartment.
15

Storage

CAUTION
Risk of injury and damage
Be aware of the weight of the device during storage.
16

Care and maintenance

16.1 Maintenance intervals

Note
In order to preserve warranty claims, all servicing and
maintenance work during the warranty period has to be
performed by an authorised Kärcher Customer Service, in
accordance with the inspection check list.
Time & date Activity
Daily Check the oil level in the
high-pressure pump, refill
with oil if necessary
Daily General visual inspection
of the WRS 200
Daily Check the water filter,
clean if necessary
30
Time & date
Daily
Weekly
After the first
50 operating
hours
Every 50 oper-
ating hours or
weekly
Every 600 op-
erating hours
or annually
16.2 Check/clean the water filter
Casing
1
Water filter
2
Seal
3
1. Open the left-hand door.
2. Visually check the water filter externally for soiling.
3. For removing the water filter:
a Close off the water inlet.
b Allow the pump to run briefly until the housing is emp-
ty.
c Unscrew and remove the casing.
d Check the seal and replace if necessary.
4. Clean the water filter and replace if necessary.
Lubricate the housing seal and sealing surface of the
water filter with silicone grease.
5. Install in the reverse order.
6. Open the water inlet.

16.3 Refilling oil in the high-pressure pump

CAUTION
Risk of burns!
By whom
Allow the high-pressure pump to cool down before refilling
Operator
with oil.
ATTENTION
Check the oil level when the high-pressure pump has
Operator
cooled down.
Operator
English
Activity
Check the filling level in the
system care container and
fill with RM 110 if neces-
sary
Check the fastening
screws for tight seating
Replace the oil in the high-
pressure pump
Check the battery, see the
information on the battery
Replace the oil in the high-
pressure pump
By whom
Operator
Operator
Customer Ser-
vice
Operator
Customer Ser-
vice