Technical Data; Declaration Of Conformity - Bosch GST 85 P Professional Originalbetriebsanleitung

Downloaded from www.Manualslib.com
OBJ_BUCH-431-002.book Page 18 Tuesday, April 8, 2008 11:09 AM
18 | English

Technical Data

Jigsaw
Article number
Stroke rate control
Rated power input
Output power
Stroke rate at no load n
0
Stroke
Cutting capacity, max.
– in wood
– in aluminium
– in non-alloy steel
Bevel cuts (left/right), max.
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
02.04.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
1 609 929 N90 | (8.4.08)
manuals search engine
GST 85 P
Professional
0 601 584 1..
–
W 580
W 350
spm 3100
mm 26
mm 85
mm 20
mm 10
° 45
kg 2.4
/ II
Assembly
Replacing/Inserting the Saw Blade
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can be
found at the end of these instructions. Use only
T-shank saw blades. The saw blade should not be
longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Before inserting the saw blade 9, set the adjust-
ing lever for orbital action 6 to setting III .
– Press the orange pushbutton in the rotatable
top handle 1 down until it can be felt to en-
gage.
Bosch Power Tools
GST 85 PE
Professional
0 601 584 6..
580
350
500 – 3100
26
85
20
10
45
2.4
/ II