Turbo Mode; Checking The Charge Status Of The Battery; Working With The Leaf Blower - Parkside PLSA 40-Li B1 Originalbetriebsanleitung

GB IE
1. Press and hold the on/off switch (4) to
start the device.
2. In order to regulate the suction/
blowing power, press the volume
control (3).
Pressing
Pressing
The 4 LEDs below the charge level
indicator (18) indicate the level of the
suction/blowing power.
3. To switch off, briefly press the on/off
switch (4).

Turbo mode

1. Press and hold the turbo button (3.1)
to turn the suction/blowing power to
turbo power.
2. Release the turbo button to exit turbo
mode.
Checking the charge status
of the battery
The charge level indicator (18) shows the
charge status of the batteries (5) during
operation.
The charge level of the battery is indicated
by illumination of the corresponding LED
lights.
3 LEDs illuminated (red, orange and
green): Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
36
= one level higher
= one level lower

Working with the leaf blower

The leaf vacuum/blower may
only be used for the follow-
ing purposes:
- As a blower to pile up dry
leaf material or to blow mate-
rial out of places that are hard
to access (e.g. under cars)
- As a suction device to suck
up dry leaf material. The
device also functions as a
shredder in the suction func-
tion. The dry leaves are
shredded and their volume
is reduced, preparing the
material for later compost-
ing if desired. The shredding
intensity depends on the size
of the leaf material and its
residual moisture. Uses other
than those described here
may damage the machine
and put the operator at risk.
During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do
not suck up any solid bodies such
as stones, branches or pieces of
branch, fir cones or similar, since
these can damage the device, in
particular the shredding mechanism.
Repairs of this type are not
covered by the guarantee.
Blowing operating mode:
For safety reasons, make
sure that the protective cover
( 7) is inserted onto the
A
suction aperture.