Start Playback - AEG DVD 4549 LCD Bedienungsanleitung

English
50
Load CD/DVD
Screen Display of CD-Menu
Screen Display of DVD-Menu

Start Playback

1. Open the TFT Display (Fig. 1/1) at the lower end of the device
upwards.
2. Insert the CD/DVD.
3. Close the CD compartment again. A moment later the loaded
media type is displayed (e.g. "DVD").
For CDs the following status information is displayed:
■
Current track/total number of tracks (1).
■
Time (2):
Here you ind information about playing time and re-
maining time. By default the elapsed playing time of the current
track is displayed in minutes and seconds. Repeatedly press the
DISPLAY button (Fig. 3/1) on the remote control for further time
displays.
You have the following options
- remaining time until the end of the track,
- elapsed playing time CD,
- remaining time until the end of the CD
You may display the screen menu for DVD use by pressing the DISPLAY
button (Fig. 3/1).
DVD-menu
■
Current title/total number of titles (1).
■
Current chapter/total number of chapters (2).
■
Time (3): Here you ind information about playing time and
remaining time. By default the elapsed playing time of the cur-
rent track is displayed. The time is displayed in hours, minutes and
seconds. Repeatedly press the DISPLAY button (Fig. 3/1) on the
remote control for further time displays.
You have the following options
- remaining time until the end of the title,
- elapsed playing time chapter,
- remaining time until the end of the chapter,
- display off.
1. Insert CD/DVD into CD/DVD-compartment a Page 50, "Load CD/
DVD".
2. Press the " PLAY/PAUSE" button (Fig. 3/5) on the remote con-
trol.
NOTE:
If the play does not start up or the play quality is poor, check the
default settings on the DVD-Players.