Features & Functions; Technical Data - Klarstein 10015798 Handbuch

Thanks for selecting & using our ATOMIZING DECORATIVE LAMP (Flower lotus bowl) ANION DECORATIVE
LAMP. For proper using it, please read the instructions manual carefully before operating, and confirm to
keep it well for speeding reference & settling a problem while you catch a problem for using it in future.
 Following the principle of medical inhalators, the ultrasonic mist maker generates „water smoke".
An optimum room climate can thus be created.
 The Changing LED Lamp generates comfortable & relaxing lighting.
 It is designed with IC & omni-seal, assured it for a long time dunking use in the water.
 While the water is not enough, there has a water-lever sensor switch to switch off the unit
automatically and the four red led light will keep flash per 1.5second until adding enough water
or without electricity, avoiding damaging the ceramic disc due to it continue to work at no water.
At this time, do not touch the sensor, or it will damage the mist maker.
 When using the unit, once the water is not enough, the mist maker will stop producing mist and
the four red led light will keep flash per 1.5second until adding enough water or without electricity.
 It is easy to clean & replace the ceramic disc.
 You could use your favorite essential oil in this aroma lamp, the essential oil must be water-
solubility, or it will damage the ceramic disk.
Working Voltage
(VDC)
24
Generate mist
(ml/h)
≥250
ASSEMBLY AND OPERATING INSTRUCTIONS
1. For initial use, be sure the input voltage marked on the transformer must be same as your local
power supply. If not, please don't use it until get a correct transformer from your local distributor.
2. Place the water guard which has been installed electronic unit in the center of glass bowl, Pull
power cord through the hole of glass bowl. Stuff up rubber tuck. (Don't pull power cord in the
bowl to avoid rubber tuck removing.)
3. Place the glass bowl on the wood stand.
4. Place the small glass cover on the stand of water guard.
5. Fill the bowl with water up to about 1/3 from the low edge of the bowl. It is better to let the
water surface 1cm~2cm over upon the mist maker.
6. Plug the mist maker & lamp into the transformer.
7. Place the transformer in a dry place away from mist.
8. Plug the transformer into power source and unit will start working
immediately.
INSTRUCTIONS MANUAL
FEATURES & FUNCTIONS

TECHNICAL DATA

Working Electric
Current (A)
0.50
Water temp. Range ( ℃ )
15 ~ 50
Ultrasonic
Frequency(KHz)
1700±40
Lifespan of Ceramic
Disc ( hour)
>2000
6