Specifications - Makita 4105KB Benutzerhandbuch

ENGLISH (Original instructions)
1-1. Wing nut
1-2. Base
2-1. Notch
3-1. Switch trigger
4-1. Restart button
5-1. Outer flange

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in brick and concrete
without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be used
in a preliminary assessment of exposure.
Downloaded from www.Manualslib.com
Explanation of general view
5-2. Base
5-3. Thumb nut
6-1. Socket wrench
6-2. Wrench
7-1. Inner flange
7-2. Diamond wheel
Model
Wheel diameter
Max. cutting capacity
-1
No load speed (min )
Overall length
Net weight
Safety class
) : 102 dB(A)
pA
) : 113 dB(A)
WA
Wear ear protection
2
) : 5 m/s
h
2
manuals search engine
ENE024-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG102-3
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Dustless Cutter
ENG229-3
Model No./ Type: 4105KB
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
7-3. Outer flange
7-4. Hex bolt
8-1. Dust spout
10-1. Limit mark
11-1. Screwdriver
11-2. Brush holder cap
4105KB
125 mm
40 mm
7,500
230 mm
3.1 kg
/II
Corporation as the responsible
ENH101-14