Selecting And Changing Speeds - Westfalia RWL 1000 IA Bedienungsanleitung

1. First of all, find the centre of the
workpiece as exactly as possible and
mark its position.
2. Place the workpiece on the face plate
and adjust until the marked centre of the
workpiece is in line with the middle of the
central hole in the face plate. You can
now mark the fastening points on the
workpiece through the other holes in the
face plate.
Depending on the type of wood, it may
be necessary to pre-drill holes in the fastening points so that the wood
does not crack when screwing in the fastening screws.
3. You can now fasten the workpiece onto the face plate using wood screws
and screw the face plate onto the shaft (fig. 9).

Selecting and Changing Speeds

The correct speed depends on a number of factors, including the type of wood
and the diameter of the workpiece.
The harder the wood, the higher the rotational speed should be.
The diameter of the workpiece also determines the
ideal rotational speed as the speed of the workpiece
surface is decisive.
And the smaller the diameter of a workpiece, the lower
the surface speed with the same rotational speed.
The smaller the workpiece, the higher the speed shoud
be.
The RWL 1000 offers four different speeds. You can
see which transmission stage is currently being used
by the drive belt by looking through the window (A)
located at an angle above the ON/OFF switch.
Operation
Fig./Abb. 9
16
Fig./Abb. 10