Device Description; Installation; Initial Startup; Operation - Kärcher LMO 18-36 Battery Originalbetriebsanleitung

Device description

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Front wheel
1
Cutting height adjustment lever
2
Battery pack release
3
Battery flap
4
Type plate
5
Cable holder
6
Motor control cable
7
Handle
8
Starter button
9
ON/OFF switch
10
Quick-release screw
11
Grass catcher filling level indicator
12
Grass catcher
13
Quick-release catch
14
Rear wheel
15
Mulch plug
16
*Charger
17
*Rechargeable battery pack
18
Safety key
19
* optional
Rechargeable battery pack
The device can be operated with a 18V Kärcher Battery
Power battery pack.

Installation

Installing the handle
1. Fold over the lower section of the handle.
Illustration B
2. Lock the handle with the quick-release catch.
Illustration C
3. Screw the upper section of the handle at the desired
height.
Illustration D
4. Fasten the motor control cable using the cable hold-
er.
Illustration E

Initial startup

Attaching the mulch plug
The mulch plug is used when the mown grass is to re-
main on the lawn.
1. Open the ejection chute flap.
Illustration F
2. Insert the mulch plug into the ejection chute.
3. Close the ejection chute flap.
20
Installing the grass catcher
The grass catcher is used when the mown grass is to be
collected for disposal.
1. Open the ejection chute flap.
Illustration G
2. Remove the mulch plug.
3. Install the grass catcher on the ejection chute. Take
care to ensure that the ejection chute flap locks the
grass catcher in place.
Illustration H
Installing the battery pack
1. Open the battery flap.
Illustration I
2. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
3. Insert the safety key.
4. Close the battery flap.
General information on handling the
The run time of the battery depends on several factors:
● The condition, length and density of the grass
● The cutting height setting
The maximum surface performance, depending on the
state of the grass, with a 5 Ah battery pack:
2
approx. 350 m .
The results of the mowing process can be optimised as
follows:
● Cut at a maximum of one third of the grass height.
● Reduce the speed at which push the device when
mowing tall grass.
Note
Do not mow wet grass. Wet grass sticks to the under-
side of the lawnmower and prevents correct collection of
the grass in the grass catcher or ejection of the grass.
WARNING
Lifting or tipping the lawnmower during operation
Incision injuries
The blade of the lawnmower rotates approximately par-
allel to the ground over which it moves. Take care to en-
sure that all four wheels touch the ground when
mowing.
1. Install the grass catcher or mulch plug (see Chapter
Initial startup).
2. Set the cutting height using the cutting height adjust-
ment lever.
Illustration J
Choose the cutting height according to the condi-
tion, length and density of the grass (see Chapter
General information on handling the lawnmower).
Illustration K
3. Press the start button and the ON/OFF switch.
Illustration L
The device starts.
4. Release the start button and hold the ON/OFF but-
ton pressed.
Empty the grass catcher regularly when using the grass
catcher, otherwise the ejection chute can become
clogged with cut grass (see Chapter Emptying the
grass catcher).
English

Operation

lawnmower
Mowing lawns