Name Of Parts; Units Installation - Hitachi RPI-16.0FSN3PE Installations- Und Betriebshandbuch

2 Name of parts

2 NAME OF PARTS
RPI-(16.0/20.0)FSN3PE


3 UNITS INSTALLATION

D A N G E R
• Check to ensure that the accessories are packed with the
indoor unit.
• Do not install the indoor units outdoors. If installed
outdoors, an electric hazard or electric leakage will occur.
• Consider the air distribution from each indoor unit to the
space of the room, and select a suitable location so that
uniform air temperature in the room can be obtained.
• Avoid obstacles which may hamper the air intake or the
air discharge flow.
• Do not install the indoor units where electromagnetic
wave is directly radiated to the electrical box, remote con-
trol cable or remote control switch.
• Prepare a steel box and install the remote control switch
in it. Prepare a steel conduit tube and wire the remote
control cable in it. Then connect the ground wire with the
box and tube.
• Install a noise filter when the power supply emits harmful
noises.
• This unit is exclusive non electrical heater type indoor
unit. It is prohibited to install a electrical heater in the
field.
• Do not put any foreign material into the indoor unit and
check to ensure that none exist in the indoor unit before
the installation and test running. Otherwise a fire or failu-
re, etc., may occur.
Downloaded from www.Manualslib.com
3 PMML0323A rev.2 - 06/2014
manuals search engine
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
C A U T I O N
• Do not install the indoor units in a flammable environment to
avoid a fire or an explosion.
• Check to ensure that the ceiling slab is strong enough. If not
strong enough, the indoor unit may fall down on you.
• Do not install the indoor units, outdoor unit, remote control
switch and cable within approximately 3 meters of strong elec-
tromagnetic wave radiators such as medical equipment.
• Do not install the indoor units in a machinery shop or kitchen
where vapor from oil or mist flows to the indoor units. The
oil will deposit on the heat exchanger, thereby reducing the
indoor unit performance, and may deform. In the worst case,
the oil damages the plastic parts of the indoor unit.
• To avoid any corrosive action to the heat exchangers, do not
install the indoor units in an acid or alkaline environment.
• When lifting or moving the indoor unit, use appropriate slings
to avoid damage and be careful not to damage the insulation
material on units surface.
Part Name
Fan
Fan Motor
Heat Exchanger
Strainer
Wiring holes
Expansion Valve
Electrical Box
Refrigerant Gas Pipe
Refrigerant Liquid Pipe
Drain Pipe
Air Filter
Hook
Air Inlet
Air Outlet
Capacitor
Fan service cover