Kenwood DMX8020DABS Schnellstartanleitung Seite 17

Ñ
3-way speaker system setup
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
+
White/Black
Gray
+
Gray/Black
Green
+
Green/Black
Purple
+
Purple/Black
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.65) in the Instruction Manual.
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.66) in the Instruction
Manual.
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.17) and Connecting
wires to terminals (P.16).
Speaker
To mid range left
speaker
To mid range right
speaker
To tweeter left speaker
To tweeter right
speaker
Speaker impedance: 4-8 Ω
Ñ
Connecting the system and
external components
12 11 10
1
2
3
4
5
1 HDMI input
Use HDMI cable KCA-HD100 (optional
accessory).
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
Digital Radio antenna CX-DAB1 (Optional
2
accessory)
!
Use of a CX-DAB1(optional accessory) as a
Digital Radio antenna is recommended.
When using a commercially available Digital
Radio antenna, the diameter of the SMB
connector must be Φ6.5 mm or less.
AV Audio output (ø3.5 mini jack)
3
FM/AM antenna input
4
Connection/Installation
15
14
13
9 8 7
6
Fixture
HDMI connector
Φ 6.5 mm (maximum)
English
17