Herunterladen Inhalt Inhalt Diese Seite drucken

Specifications; Accessories Supplied - Sony PDBK-201 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
Notes about i.LINK
connections
• Check that connectors are oriented properly before
connecting an i.LINK cable to your computer or to the
PDW-HD1500/F1600. Trying to force an improperly
oriented connector may damage the connector or the
PDW-HD1500/F1600.
• Connect the i.LINK cable to your computer before
connecting it to the PDW-HD1500/F1600. The PDW-
HD1500/F1600 may be damaged by static electricity if
you connect the cable to the PDW-HD1500/F1600 first.
• Before connecting or disconnecting an i.LINK cable
between the PDW-HD1500/F1600 and other equipment
with an i.LINK connector, always power both the PDW-
HD1500/F1600 and the connected equipment off and
disconnect all power plugs from their power outlets.
Inserting or removing an i.LINK connector with the
power plugs still connected may cause a damaging surge
of high-voltage power to flow from the equipment's
i.LINK connector into the PDW-HD1500/F1600.
• A damaging surge of high-voltage power can still flow
into the PDW-HD1500/F1600 from the i.LINK
connector of connected equipment even when a separate
i.LINK cable is connected to another i.LINK connector
on the equipment, for example when connecting a hard
disk to a computer with an i.LINK interface card that
provided multiple connectors.
Always power all equipment off and disconnect all
power plugs from their power outlets, both on the PDW-
HD1500/F1600 and on the connected computer and its
peripherals, before connecting an i.LINK cable.
• Before turn on or off the power switch of the PDW-
HD1500/F1600, always stop operation of all devices
connected to the PDW-HD1500/F1600 over the i.LINK
interface.
• If MPEG TS signal transmission is not possible with the
PDW-HD1500/F1600 powered on, turn off the power
switch of the PDW-HD1500/F1600 and then turn it on
again.
10
Notes about i.LINK connections / Specifications

Specifications

General
Power requirements and current consumption
+5.8 V, 0.1 A
+3.3 V, 0.7 A
+2.5 V, 0.5 A
(Power is supplied from PDW-
HD1500/F1600.)
Dimensions (w/h)
102×86 mm (4
Mass
Approx. 75 g (2.6 oz)

Accessories supplied

Fitting screw (4)
Operation and Installation Guide (1)
Installation Manual (1)
Design and specifications are subject to change without
notice.
Note
Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR DAMAGES
OF ANY KIND INCLUDING, BUT NOT LIMITED
TO, COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO FAILURE OF
THIS UNIT, EITHER DURING THE WARRANTY
PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
1
1
/
×3
/
inches)
8
2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis